User guide

Keyboard Structure Operation Instructions SC Cutting Plotters
Page
30
AP-75026 Rev 1.0 - 11/01/00
It is possible to request up to 100 copies by changing the
REPLOT
MULTIPLICATION FACTOR
in the plotter set-up. This way, you can
activate a multiplication factor of 2, 5 or 10.
d) Press ENTER. The cutter will immediately start cutting. An
automatic pre-feed cycle will automatically take place after every
replot.
The
ENTER
key has to be pressed to confirm requested changes to
the plotter settings. A requested change will always be shown by one
or more flashing LEDs of the parameter to be changed. Pressing
ENTER will stop the flashing, indicating that the new setting has been
accepted.
The ENTER key also carries a blue dot, indicating it can be pressed
together with another key to access one of the special functions
indicated in blue on the control panel.
The
MENU SELECTION KEYS
enable the user to go over the different
plotter parameters, for viewing or changing.
The available parameters are :
TOOL, FORCE, SPEED,
ACCELERATION
and
PAGE LENGTH.
Each of them is listed on the
control panel. The selected parameter is shown with an LED.
In ON-LINE MODE, the menu selection keys will allow you at any time to
verify the actual settings. You will not be able to change them.
In OFF-LINE mode, you are able to select a parameter and change the
value or the tool selection using the VALUE-keys.
The
value
keys can be used to alter settings or to change parameter
values. To change tools or values, you have to switch to OFF-LINE
mode. After having selected the parameter you wish to alter, press one of
the value keys to change the parameter accordingly. After having pressed
one of the value keys once, the LED-bar or LED indicating the value or
the tool will blink. The ENTER key has to be pressed to save the new
setting. Pressing one of the MENU-keys again before pressing ENTER
will exit the alteration.