User guide

Preparing for a job Operation Instructions SC Cutting Plotters
Page
25
AP-75026 Rev 1.0 - 11/01/00
SUMMARY OF AVAILABLE VALUES/SETTINGS FOR CUTTER
PARAMETERS - IMPERIAL SYSTEM
All speeds are given in inch per second.
SPEED
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
TOOL 1
4 8 12 16 20
24 28 32 36 40
TOOL 2
4 8 12 16 20
24 28 32 36 40
TOOL 3
2 4 6 8 10 12 14
16 18 20
TOOL 4
4 8 12 16 20
24 28 32 36 40
Tool-Up
4 8 12 16 20 24 28
32 36 40
All accelerations are given in G (m/s²).
ACCEL.
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
TOOL 1
0.5 1 1.5
2 2.5 3.0 3.5 4.0 - -
TOOL 2
0.5 1 1.5
2 2.5 3.0 3.5 4.0 - -
TOOL 3
0.5 1 1.5
2 2.5 3.0 3.5 4.0 - -
TOOL 4
0.5 1 1.5
2 2.5 3.0 3.5 4.0 - -
Tool-Up
0.5 1 1.5
2 2.5 3.0 3.5 4.0 - -
All forces are given in grams (1 g = 0.01 Newton)
FORCE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Range 1
15 20 30 40 50 60 70 80 90 100
Range 2
110 120 130 140 150 160 170 180 190
Range 3
200 200 200 200 250 300 350 400 450 500
Defaults: TOOL 1 (Knife1) 100 g TOOL 2 (Knife2) 100 g
TOOL 3 (Pen1) 20 g TOOL 4 (Pen2) 140 g Sheet-Off 500 g
All distances are given in inches
PAGE
LENGTH
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
Length
0162432
40 80 120 160 200 400
Remark:
Factory Default Settings: TOOL 1 = Knife 1 TOOL 2 = Knife 2
TOOL 3 = Pen 1 TOOL 4 = Pen 2