User guide

Preparing for a job Operation Instructions SC Cutting Plotters
Page
22
AP-75026 Rev 1.0 - 11/01/00
13) If needed, you can now restart the offset setting routine to experiment with a different
force, speed and/or acceleration. Refer to item 3) to do this.
14) If you are satisfied with the new setting, you can set the cutter ONLINE by pressing the
ONLINE key. ONLINE LED should be ON.
15) Now press PAGE to sheet-off the test squares.
In order to obtain good quality, MUTOH recommends you to perform this routine
each time you change cutting blades or switch to another type of media
.
To be able to change swiftly from one application or media to another, your cutter can
memorise 4 sets of tool parameters. Each of the TOOLS can be defined as being a
knife, a pen or a pouncing tool, depending of the user’s choice. The factory default
settings are: TOOL1 = Knife, TOOL2 = Knife, TOOL3 = Pen, TOOL4 = Pen. Please
refer to selecting a tool.
1) Inaccurate offset setting
may cause :
♦
POOR cutting quality
.
♦
Difficult weeding.
2)
In case the
offset adjustment routine
is
aborted,
the
cutter will
continue working with the value prior to launching the
adjustment routine.