User guide

Operation Instructions SC Cutting Plotters

AP-75026 Rev 1.0 - 11/01/00



This document may not be reproduced by any means, in whole or in part, without written

permission of the copyright owner.

This document is furnished to support the MUTOH SC Series cutting plotters. In

consideration of the furnishing of the information contained in this document, the party to

whom it is given assumes its custody and control and agrees to the following:

1. The information herein contained is given in confidence, and any part thereof shall not

be copied or reproduced without written consent of Mutoh Europe N.V.

2. This document or the contents herein under no circumstances, shall be used in the

manufacture or reproduction of the article shown and the delivery of this document shall

not constitute any right or license to do so.

FCC WARNING

This equipment complies with the requirements for a class A computing device in the FCC

rules, part 15, subpart J.

Operation of this device in a residential area may interfere with television reception or

operation of utilities.

Cutters generate weak radio signals and may interfere with television reception and

utilities. If the cutter does interfere with radio or TV reception, try the following:

•

Change the direction of your radio and TV reception antenna or feeder.

•

Change the direction of the cutter.

•

Move either the cutter or the receiving antenna so that there is more distance between

them.

•

Be sure the cutter and the receiving antenna are on separate power lines.