User guide

Preparing for a job Operation Instructions SC Cutting Plotters

Page

AP-75026 Rev 1.0 - 11/01/00

SETTING THE TOOL SPEED

1. Switch the cutter to OFF-LINE mode. This can be done by switching the cutter ON

without loading media or when media has been loaded before, by pressing the ON-

LINE button. The cutter is in OFF-LINE mode if it is switched on, without the ON-LINE

LED being lit.

2. Using the MENU selection keys, select the SPEED option (LED next to SPEED must

be ON).

3. The actual SPEED setting for the selected tool will now be shown on the LED-bar.

Viewing of the value can be performed in OFF-LINE as well as in ON-LINE mode.

4. Using the VALUE +/- keys, the user can now alter the SPEED settings. Please note

that the indicated value only refers to the TOOL-DOWN speed of the selected tool. The

TOOL-UP speed can be set separately.

5. Press ENTER to confirm or press one of the menu keys to exit.

All values being used or available are shown in

the table at the end of this chapter.

ACCELERATION SELECTION

1. Switch the cutter to OFF-LINE mode. This can be done by switching the cutter ON

without loading media or when media has been loaded before, by pressing the ON-

LINE button. The cutter is in OFF-LINE mode if it is switched on, without the ON-LINE

LED being lit.

2. Using the MENU selection keys, select the ACCELERATION option (LED next to

ACCELERATION must be ON).

3. The actual ACCELERATION setting for the selected tool will now be shown on the

LED-bar. Viewing of the value can be performed in OFF-LINE as well as in ON-LINE

mode.

4. Using the VALUE +/- keys, the user can now alter the ACCELERATION settings.

5. Press ENTER to confirm or press one of the menu keys to exit.

All values being used or available are shown in

the table at the end of this chapter.