User guide

Preparing for a job Operation Instructions SC Cutting Plotters

Page

AP-75026 Rev 1.0 - 11/01/00

10 20 30

Drag Knife

Pen

Pounce

To change the TOOL TYPE for the currently selected TOOL PRESET, proceed as follows:

1. Via the MENU keys, select the TOOL menu (LED next to TOOL must be ON). Please

make sure the cutter is OFF-LINE.

2. Press the

VALUE +

key to alternatively select DRAG KNIFE, PEN, PUNCHING tool.

You will notice the LED in the LED bar jump from 10% (Knife) to 20% (Pen) to 30%

(Pounce) as you press the VALUE + key.

3. Press ENTER to confirm the TOOL TYPE selection.

Please note it is possible to combine the selection of Tool Preset with changing the TOOL

TYPE of the TOOL Preset you select. To do this, first select the preset with the VALUE -

key, then change the TOOL TYPE with the VALUE + key and press ENTER.

When TOOL-UP is selected, the FORCE adjustment refers to the

FORCE which will be used for automatic sheet-off.

GENERAL PROCEDURE TO CHANGE SETTINGS ON THE

CUTTER

1. Switch the cutter to OFF-LINE mode. This can be done by switching the cutter ON

without loading media or, when media has been loaded before, by pressing the ON-

LINE button. The cutter is in OFF-LINE mode if it is switched on, without the ON-LINE

LED being lit.

2. Using the MENU-keys, the user selects one of the five different parameters (TOOL,

FORCE, SPEED, ACCELERATION, PAGE LENGTH).

3. Using the VALUE keys, the user adjusts the settings for the selected parameter. The

key

will increase the value or

select the next parameter. The

- key

will decrease the

value or select the previous parameter. A requested change will always be indicated by

one or several blinking LEDs.

4. Press ENTER to confirm the requested change. The blinking will stop, indicating that

the new setting has been saved. To exit without a change, the user has to press one of

the menu keys.