User guide

Preparing for a job Operation Instructions SC Cutting Plotters

Page

AP-75026 Rev 1.0 - 11/01/00

INSTALLING A TOOL

At the right-hand side of the cutter head, you will find a pivoting mounting bracket /

mounting clips. Opening this bracket / holding back these mounting clips will enable you to

install a full range of cutting and drawing tools.

1. Open the screw to unlock the tool head mounting bracket.

2. Hold back the clip of the tool head and slide the tool into position, making sure the tool

collar fits into the groove just beneath the locking screw.

3. Fasten the screw to secure the tool into position.