User guide

Preparing for a job Operation Instructions SC Cutting Plotters
Page
13
AP-75026 Rev 1.0 - 11/01/00
STANDARD KNIFE HOLDER OPTIONAL KNIFE HOLDER WITH NONIUS
2) Turning the set screw (3) clockwise
will make the blade protrude out of
the edge of the base part (1). Turning
the set screw (3) counterclockwise,
will retract the blade.
For a first test, turn out the blade until
it protrudes about 0.2 mm (0.008”) out
of the base part
2) Take the base part and the ring in your left
hand and twist the shaft until the knife
point protrudes about 0.2 mm (0.008”) out
of the edge of the base part.
Tighten the ring firmly against the base
part. This will prevent the cutting blade
from coming loose during cutting.
3) Make a manual test-cut on a small piece of media, of the same type that you will be
using. Adjust the depth until the top layer is cut completely and that you can see a
slight scratch on the backing when peeling off.
At no times you should be able to
see a scratch at the back side of the media.
4) Repeat steps 2 and 3 until the correct depth is obtained.