User guide

Preparing for a job Operation Instructions SC Cutting Plotters
Page
11
AP-75026 Rev 1.0 - 11/01/00
position,
pull the front edge of the media
forward so that there is an even tension
across the whole width of the roll
. (=
Equal Tension method).
4) Put the hold lever in the DOWN
position and close the cover.
This action will initialise the media
loading sequence, during which the
cutter will measure the loaded sheet.
The sheet will be shuffled back and
forth, enabling the cutter to determine
the media size and enabling you to
verify the media transport.
4) At this stage, put the hold lever in the
DOWN position. Adjust the position of
the small conveyor flanges so that they
are just alongside the roll of vinyl. This
action will initialise the media loading
sequence, during which the cutter will
shuffle a pre-set distance of vinyl. The
media will be shuffled back and forth
enabling you to verify the media
transport. The page length (pre-feed
length) is factory-set to 1 m (40”) and can
be adjusted by the user.
5) After finishing the media loading sequence, the tool head will be parked at the origin
position and the cutter will be in ON-LINE mode, ready to receive data from the host
computer.
Do not try to move the pressure rollers when the media hold lever is in
the down position as this may cause damage to the system.