User guide

Preparing for a job Operation Instructions SC Cutting Plotters
Page
10
AP-75026 Rev 1.0 - 11/01/00
3) Always adjust the position of the pressure rollers so that they align well with the drive
rollers so that they are in line with the drive roller. The right pressure roller’s movement
is limited so that it can never be malpositioned.
Always make sure that the pressure rollers
are completely inside the sheet of media
you want to load. Especially when you use a
cut-sheet of which the corners are not
perfectly square, it is best to put the
pressure rollers well inside the vinyl as the
width of the sheet may vary.
Always make sure that both pressure rollers
are at least 5 mm (0.2”) inside the media. It
is not recommendable that the rollers run on
the very edge of the material.
Please do not use the marker lines to align a roll of media!
They are for use with
cut-sheets only!
Rolls can only be correctly
installed using the
EQUAL TENSION METHOD
.
In case you are using an
SC-1000
or
larger
, you have the opportunity to use either
two or
three pressure rollers
, depending on the width of the vinyl you are using. When not using
the left pressure roller (i.e. when loading vinyl of a small width), the left pressure roller
should be placed at the
extreme left
of the cutter (that is,
not on top of a grid roller
).
Please note that the
middle pressure roller
should always be placed
on top of a grid
roller
. Close the protective cover.
It is best that you
hold the front edge of
the media in the middle
with one hand and
with the other hand, the roll itself.
As you are holding the roll firmly into