User guide

Setting up the cutter Operation Instructions SC Cutting Plotters
Page
7
AP-75026 Rev 1.0 - 11/01/00
•
When ENTER is pressed with the head above any of the other options, only
that line is plotted with its different parameter possibilities. After this, the
head will be parked above the current setting.
The communication
settings can be found in lines 8 to 16.
8) With the
& JOG-keys you can return to the MENU-SELECTION LINE
leaving the original setting unchanged.
9) With the & JOG-keys, the head can be positioned above the desired
setting, after which the ENTER key needs to be pressed to save the new setting
into memory. When ENTER has been pressed, the head returns to the MENU-
SELECTION-LINE.
10) The cutter will return to its normal operation mode by putting the media hold
lever in the “up” position and removing the SET-UP SHEET from the cutter.
8.
Communication DEFAULT 1 DEFAULT 2 DEFAULT 3 DEFAULT 4 DEFAULT 5 USER
DEFINED
9. BAUDRATE
9600 9600 9600
9600
9600 Adjustable
10. DATABITS
787
8
8 Adjustable
11. PARITY
EVEN NONE EVEN
NONE
EVEN Adjustable
12. STOPBITS
111
1
2 Adjustable
13. SOFTWARE
HANDSHAKE
OFF OFF Xon/Xoff
Xon/Xoff
OFF Adjustable
14. DTR-Pin
ON ON OFF
OFF
ON Adjustable
15. CTS-Pin
OFF OFF OFF
OFF
OFF Adjustable
16. RTS-Pin
ON ON ON
ON
ON Adjustable
The factory default settings are shown in
Bold
-face.
CHANGING THE SET-UP LANGUAGE OF YOUR CUTTER
It is possible to change the user language of your cutter, thus changing the set-up sheet
language. Changing the set-up language can be done by pressing two keys
simultaneously during power-up. See table below for an overview.
LANGUAGE KEY COMBINATION
American
(dimensions in inches)
ENTER + JOG-DOWN
German
ENTER + JOG-UP
French
ENTER + JOG-RIGHT
English
(dimensions in metric units)
ENTER + JOG-LEFT
Japanese
ENTER + ONLINE