Specifications

Maintenance Manual – SC Cutting Plotter
54 AP-74030, Rev / B
Caution :
After replacement of the cutting head the following electronically adjustments have to be
performed :
· Cutting mat height measurement (Please refer to 5. Diagnostic menu
with SC-board or with optional LCD keyboard).
· Adjusting the sheeting off system (Please refer to 5. Diagnostic menu
with SC-keyboard or with optional LCD keyboard) (Not for SC-550)
· Pen force calibration (Please refer to 5.3. Diagnostic menu with
optional LCD keyboard).
6.2.7. Grid rollers : removal and installation.
Step 1 : Remove the grid cover (Please refer to 6.2.5. Grid cover).
Step 2 : Unscrew the two screws from the X-motor a few turns and remove the X-drive belt.
Step 3 : Unscrew all the grid rollers (with 1.5mm hex-key) and pull out gently the shaft out of the machine.
In this way every grid roller can be removed from the shaft.
Caution :
q Never replace only one grid roller but always the whole set. Replacement of only
one grid roller may result in noticeable deviation of media tracking!
q Before unscrewing the grid rollers, mark the position of every roller on the shaft.
This will simplify the reinstallation.
q NEVER unscrew or change the position of the bearing blocks on the X-rail as this
will result in misalignment of the grid roller shaft!
Note :
To reinstall the grid rollers perform above steps in reversed order.
Caution :
After reinstallation of the grid rollers, the X-drive belt tension should be adjusted (lease
refer to the adjustment of the X-drive belt).