Specifications

Maintenance Manual – SC Cutting Plotter
45 AP-74030, Rev / B
3) CUTTER (Sheet – Off system).
(Not for SC-550)
A) Adjustment of the Sheet-Off system.
This calibration stores the position in the EEPROM where the penhead makes the knife catch
bracket grabbing the sheet-off knife.
F3
* Adjust – 09 *
PenForce Cutter
F4
Press F4
F3
Cutter
Adjust Aging
Select or EXIT
F4
Press F3
Wait until
Finished then
Press ENTER
Press ENTER
Place Pen head
so that it can
take the knife
and press ENTER
The head moves to the left hand side and stops approx.
60mm before the left side of the machine.
Open the transparent cover and move the head manually to
the utmost left position.
Press ENTER
The correct position is that the head is at the left as much
as possible but that the knife catch bracket is still free to
move UP/DOWN. Check that the head can catch the
The adjusted
value = -XX.XX
Press ENTER to
save or EXIT
Bracket and can hold it firmly.
With the cover still open (VERY IMPORTANT) press
ENTER and ENTER after closing the cover the head will
travel to the right.