Specifications

Maintenance Manual – SC Cutting Plotter
22 AP-74030, Rev / B
4.1.2. COMMUNICATION ERRORS
Communication errors are caused by a problem in the communication between the cutter and the host
computer. They can be caused by errors related to the communication conditions, errors due to a defective
handshake or command format errors in the ESCAPE sequences.
ERROR CODE
10% 20% 30% 40% 50% 60% 70% 80% 90% 100%
ERROR ON-LINE FRAME (C01)
 
ERROR ON-LINE OVERRUN (C02)
 
ERROR ON-LINE PARITY (C03)
  
ERROR BIAS VALUE (C04)
 
ERROR SUM CHECK (C05)
  
ERROR DATA BLOCK (C06)
  
FEW PARAMETER ESC (C07)
   
FEW PARAMETER ESC (C08)
  
COMMUNICATION BUSY (C09)
  
UNDEFINED ESC (C10)
   
ILLEGAL ESC (C11)
  
ERROR VALUE ESC (C12)
   
MANY PARAMETERS ESC (C13)
   
COMMUNICATION ERROR (C14)
    
BUFFER OVERFLOW (C15)
 
POSSIBLE CAUSE & SUGGESTED ACTION
C01 A framing error occurred. Check the communication settings. Chapter 3.
C02 Overrun error. Check the communication settings. Chapter 3.
C03 Parity error. Check the communication settings. Chapter 3.
C04 Bias is less than EOB code. Check the communication settings. Chapter 3.
C05 Check-sum difference cutter vs. host. Check the communication settings. Chapter 3.
C06 Data between bias and EOB too large. Check the communication settings. Chapter 3.
C07 Not enough ESC-parameters. Check the communication settings. Chapter 3.
C08 Not enough ESC-parameters. Check the communication settings. Chapter 3.
C09 Change the computer program to prevent the cutter from returning double data.
C10 Undefined ESCAPE sequence. Check the ESCAPE command setup.
C11 Illegal character used for MH-GL ESC-sequence. Check the ESCAPE command setup.
C12 Illegal character in ESC-sequence parameter. Check the ESCAPE command setup.
C13 Too many ESC-sequence parameters. Check the ESCAPE command setup.
C14 Communication error. Restart the cutter.
C15 Buffer overflow. Restart the cutter.