User`s guide

User’s Guide Spitfire 65/90 Extreme
CHAPTER 6 : PRINTER MENU
77 AP-75197– Rev. 1.2
6.3 [F2] - CLEANING THE HEADS
When there are some missing nozzles, a cleaning should be done. Depending on the quantity of missing
nozzles and which head, a little, normal or powerful cleaning on head 1-2, head 3-4 or ALL could be done.
Step 1 : Verify the following regarding the condition of the printer.
It is not currently printing
Step 2 : Press the [F2] key of the operation panel.
To shift to the cleaning menu.
Step 3 : Press the [F1] key or the [F2] key on the operation panel.
The product will perform following operations:
Setup items Key name Parameters Description
Cut & Feed F1 ALL, Head 1  Head 2 Clean ALL heads or head couple one or two
F2 Little, normal, powerful Set the intensity of a cleaning
Step 4 : Press the [ENTER] key to start the requested cleaning.
6.3.1 [F3] - Controlling the heater elements
If you want to change or check the heater elements, follow the steps below.
Step 1 : Verify the following regarding the condition of the printer.
It is not currently printing
Step 2 : Press the [F3] key of the operation panel.
To shift to the heater menu.
The heater message can be one of the following:
Heater standby
Heater warming up
Heater ready
A stands for the heater.
B stands for the fixer.
C stands for the post fixer.
D stands for the dryer.
S stands for the Set-temperature (requested temperature).
R stands for the Real-temperature (actual temperature).