User`s guide

User’s Guide Spitfire 65/90 Extreme
CHAPTER 5 : PREPARATIONS BEFORE PRINTING
70 AP-75197– Rev. 1.2
5.5 PRINTING FLOW
The following flowchart gives you a view on which steps should be taken to make a print. This is a very short
summary of what should be done.
Select media
(Refer to the media compatibility lists on www.mutoh.be)
Load media
(Refer to the chapter Loading Media)
Perform NozzleCheck and cleanings if necessary
(Refer to the chapter TestPrinting)
Set step
(Refer to chapter Set the correct distance adjust)
Select image
Load dedicated profile ( ) and rip image
(Refer to profiles section on www.mutoh.be)
Decide which weaving pattern should be used (sign/picture)
(Refer to chapter i² technology)
Print image
It is highly recommended to use one of the profiles Mutoh is making available on the website. A lot of parameters are included.
The most important ones are:
Ink an colour management related
Ink Restrictions
Linearization
Ink limits
ICC Profile
PrintMode related
Resolution
Amount of passes
Unidirectional  Bi Directional
Weaving ON  OFF
Media related
Heater settings
Media thickness
HeadHeight
The file name of each profile is build up in the same way
For example