User`s guide

User’s Guide Spitfire 65/90 Extreme
CHAPTER 5 : PREPARATIONS BEFORE PRINTING
66 AP-75197– Rev. 1.2
5.3.2 How to determine and change the step
Step 1 : Power ON the printer.
Step 2 : Load the media to print on.
Notes
Be sure to tighten the media to the winder 100 before setting the step. This because the step will
be different when printing roll-to-sheet than when printing roll-to-roll.
Step 3 : Perform a NozzleCheck to be sure all nozzles are present. If not, perform the necessary cleanings.
Step 4 : Set the step to 100.00%
Step 5 : Print the test pattern. (SetupMenu 1/7 > TestPrint [F3] > Dist.Check [F2])
Step 6 : To evaluate the print, you should look for gaps or overlaps between the different passes (1-4). The
direction of the adjustment (increase or decrease the step adjust value) is the easiest to check in
the X-rows. To check the quality, the Y rows should be the standard.