User`s guide

User’s Guide Spitfire 65/90 Extreme
CHAPTER 3 :Basics
27 AP-75197– Rev. 1.2
Step 5 : After finishing the cleaning cycle, the media measurement screen will be displayed (in case there is
media loaded)
Step 6 : Make the correct settings and press the [F4]-key to start the media initialization.
Step 7 : If everything is done correctly, the following screen should appear.
Notes
If there are any problems during the initial start-up operation, the printer will display a message
on the operation panel, and the operation may stop. If the operation stops, refer to
"Troubleshooting", and take the appropriate actions.
Step 8 : Before start printing, be sure to perform a nozzle check to ensure all nozzles are present. If not,
perform the necessary cleaning cycles.
3.2 POWERING OFF CYCLE
Power OFF the printer according to the procedure below:
Notes
Please be sure to perform the necessary maintenance before powering OFF the machine.
Step 1 : Verify the following regarding the operational condition of the printer:
There is no printing operation being performed.
The operation panel is in the main screen.
Step 2 : Press the [POWER] key of the operation panel to switch OFF the printer.
Step 3 : [Power OFF] will be displayed for a few seconds
Following message is displayed on the operation panel.
All lamps and the LCD of the operation panel will switch OFF.
The printer will automatically perform a TubingFlush and power OFF.