User`s guide

User’s Guide Spitfire 65/90 Extreme
CHAPTER 3 :Basics
26 AP-75197– Rev. 1.2
3.1 POWERING ON CYCLE
Caution
Before powering ON the printer, verify that the waste bottle is installed and that the waste tubes
are connected to the waste bottle.
Power ON the printer according to the procedure below:
Step 1 : Press the [POWER] key of the operation panel.
The POWER lamp of the operation panel will light (green).
Step 2 : The printer will ask if you want to clean the wipers. When it is the first start up in a few hours, it is
highly recommended to press [YES]  [F2] and to clean the wipers with appropriate cleaning in
order to remove all ink and to make the wipers more elastic.
Step 3 : Press the ENTER key when you have done. The carriage will cap in again.
Step 4 : After finishing the daily maintenance, the print will automatically perform a normal cleaning.