User`s guide

User’s Guide Spitfire 65/90 Extreme
CHAPTER 6 : PRINTER MENU
113 AP-75197– Rev. 1.2
6 .6 .4.7 Sm a rtTop M enu
This feature will take care of a feed before every print. To start printing on media which is pre heated. This
function will only be visible when the B heater is activated.
Setup items Parameters Description
Smart Top Off No media feed of 5 centimetres
50 150 A media feed of xxx centimetres occurs
- [CANCEL] key: shift to the previous hierarchy menu.
6 .6 .4.8 A uto C lea ning M enu
In normal printing conditions, it is not recommended to use this function. When experiencing regular nozzle
loss, one of the three AutoCleaning features can be used.
When using this function, the wiping activity will be much higher, so be sure to securely perform your daily
and weekly maintenance.
Setup items Parameters Description
Auto Clean Waiting To perform a little, normal, powerful cleaning while printer is idle
for 1, 2, 3, 4, 5, 6, 9, 12, 18, 24 hours.
Printing To perform a little, normal, powerful cleaning after 5, 10, 15, 20,
30, 45, 60, 90, 120, 150,180 minutes of printing.
Before Printing To perform a little, normal, powerful a cleaning before every job
-  [CANCEL] key: to shift to the previous hierarchy menu.
6 .6 .4.9 C a p C ycleM enu
Perform a TubingFlush every 1 to 24 hours.
Notes
A TubingFlush is automatically performed after 10 minutes of idle and before shut down of the
printer.
Setup items Parameters Description
Cap Cycle OFF No tubing flush will be performed
1 - 24 hours Every 1  24 hours (adjustable) a TubingFlush is performed.
-  [CANCEL] key: To shift to the previous hierarchy menu.