Specifications

Operation Instructions Spitfire 65/90 Extreme
CHAPTER 5 : PREPARATIONS BEFORE PRINTING
58 AP-77140 – Rev. 1.1 – 05/04/07
5.4 PRINTING FLOW
The following flowchart gives you a view on which steps should be taken to make a print. This is a very short
summary of what should be done.
SELECT MEDIA
(Refer to the media compatibility lists on www.mutoh.be)
▼
LOAD MEDIA
(Refer to the chapter “Loading Media”)
▼
PERFORM NOZZLECHECK AND CLEANINGS IF NECESSARY
(Refer to the chapter “TestPrinting”)
▼
SELECT IMAGE
▼
LOAD DEDICATED PROFILE
(∗)
AND RIP IMAGE
(Refer to profiles section on www.mutoh.be)
▼
SET STEP
(Refer to chapter “Set the correct distance adjust”)
▼
DECIDE WHICH WEAVING PATTERN SHOULD BE USED (SIGN/PICTURE)
(Refer to chapter “I² technology”)
▼
PRINT IMAGE
∗
It is highly recommended to use one of the profiles Mutoh is making available on the website. A lot of parameters are included.
The most important ones are:
Ink an colour management related
• Ink Restrictions
• Linearization
• Ink limits
• ICC Profile
PrintMode related
• Resolution
• Amount of passes
• Unidirectional – Bi Directional
• Weaving ON – OFF
Media related
• Heater settings
• Media thickness
• HeadHeight
The file name of each profile is build up in the same way
For example