User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
99 AP-75280 – Rev. 1.2
Error Message Description Solution Category
6261
No valid frame found
No valid frame found during fast scan routine (after several
retries). Make sure all frame specifications are applied.
To check:
 Frame isn't found within
120cm. Media space
before frame bottom is
too much.
 Frame bottom doesn't
have the correct
specifications (minimum
thickness of 3mm on ALL
sides, thickness too
varying, frame height <
20cm, frame width <
10cm, frame angle < 5°)
► Contourcutting
► Square details
Error
6262
No valid frame found Only 1 frame point found during diagonal scan.
6263
No valid frame found No frame points found during diagonal scan.
6264
No valid frame found Thickness of left side of frame invalid
6265
No valid frame found Varying thickness
6266
No valid frame found Invalid thickness
6267
No valid frame found Invalid frame angle
6268
No valid frame found Requested X movement for fast scan cannot be executed.
6269
No valid frame found Invalid spot type
6271
Media shift detected
Media displacement detected during cutting. Centre markers
of previous segment are shift more than 2mm.
To check:
 Grids on media?

Pinches and grids clean?
Warning