User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
98 AP-75280 – Rev. 1.2
Error Message Description Solution Category
6241
Thickness problem
frame top
All measured points of frame top vary too much from each other! This will
influence the accuracy of the cutting.
You can try to cut the job if
you want to. Perfect quality is
not guaranteed.
What to check in case of bad
quality:
 Printer settings
 RIP settings
 Design
► Contourcutting
► Square details
Warning
6242
Thickness problem
frame top
Invalid thickness of P5 (right side of frame top). Thickness varies too much
from other top points! This will influence the accuracy of the cutting.
6243
Thickness problem
frame top
Invalid thickness of P6 (top right of frame top). Thickness varies too much
from other top points! This will influence the accuracy of the cutting.
6244
Thickness problem
frame top
Invalid thickness of P7 (top left side of frame top). Thickness varies too much
from other top points! This will influence the accuracy of the cutting.
6245
Thickness problem
frame top
Invalid thickness of P8 (left side of top point). Thickness varies too much from
other top points! This will influence the accuracy of the cutting.
6246
Thickness problem
frame top
Invalid thickness of P5 and P8. Thickness of these points varies too much
from each other AND varies also from P6 & P7! This will influence the
accuracy of the cutting.
6247
Thickness problem
frame top
Invalid thickness of P6 and P7. Thickness of these points varies too much
from each other AND varies also from P5 & P8! This will influence the
accuracy of the cutting.
6251
Thickness problem
frame centre
Thickness of centre points (P9 & P10) differs too much from each other AND
differs also from bottom points P1 and P4.
You can try to cut the job if
you want to. Perfect quality is
not guaranteed.
What to check in case of bad
quality:
 Printer settings
 RIP settings
 Design
► Contourcutting
► Square details
Warning
6252
Thickness problem
frame centre
Invalid thickness of P9 (right centre point). Thickness varies too much from
P10! This will influence the accuracy of the cutting.
6253
Thickness problem
frame centre
Invalid thickness of P10 (left centre point). Thickness varies too much from
P9! This will influence the accuracy of the cutting.
6254
Thickness problem
frame centre
Thickness of centre points (P11 & P12) differs too much from each other AND
differs also from bottom points P1 and P4.
6255
Thickness problem
frame centre
Invalid thickness of P11 (right centre point). Thickness varies too much from
P12! This will influence the accuracy of the cutting.
6256
Thickness problem
frame centre
Invalid thickness of P12(left centre point). Thickness varies too much from
P11! This will influence the accuracy of the cutting.