User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
97 AP-75280 – Rev. 1.2
Error
Message
Description
Solution
Category
6227 Print distortion – print stretch
Stretch detected on bottom of frame.
P1 & P4 have identical thickness. P2 & P3 have identical thickness.
But thickness of P1-P4 and P2-P3 differ too much from each other. Print is
stretched.
You can try to cut the
job if you want to.
Perfect quality is not
guaranteed.
What to check in case
of bad quality:
 Printer settings
 RIP settings
 Design
► Contourcutting
► Square details
Warning
6228 Print distortion – print stretch
Stretch detected on top of frame.
P5 & P8 have identical thickness. P6 & P7 have identical thickness.
But thickness of P5-P8 and P6-P7 differ too much from each other. Frame (print
result) is stretched!!!
6229 Print distortion – print stretch
Stretch detected on side of frame.
Px & Py have identical thickness. Pw & Pz have identical thickness.
But thickness of Px-Py and Pw-Pz differ too much from each other. Frame (print
result) is stretched!
Depending on kind of measured segment :Px, Py, Pw, Pz are different
1) Px = P1, Py = P4, Pw = P5, Pz = P8
2) Px = P1, Py = P4, Pw = P9, Pz = P10
3) Px = P9, Py = P10, Pw = P11, Pz = P12
4) Px = P11, Py = P12, Pw = P5, Pz = P8
6231
Thickness problem
frame bottom
All measured points of frame bottom vary too much from each other! This will
influence the accuracy of the cutting.
You can try to cut the
job if you want to.
Perfect quality is not
guaranteed.
What to check in case
of bad quality:
 Printer settings
 RIP settings
 Design
► Contourcutting
► Square details
Warning
6232
Thickness problem
frame bottom
Invalid thickness of P1 (right side of frame bottom). Thickness varies too much from
other bottom points! This will influence the accuracy of the cutting.
6233
Thickness problem
frame bottom
Invalid thickness of P2 (bottom right of frame bottom). Thickness varies too much
from other bottom points! This will influence the accuracy of the cutting.
6234
Thickness problem
frame bottom
Invalid thickness of P3 (bottom left side of frame bottom). Thickness varies too
much from other bottom points! This will influence the accuracy of the cutting.
6235
Thickness problem
frame bottom
Invalid thickness of P4 (left side of bottom point). Thickness varies too much from
other bottom points! This will influence the accuracy of the cutting.
6236
Thickness problem
frame bottom
Invalid thickness of P1 and P4. Thickness of these points varies too much from
each other AND varies also from P2 & P3! This will influence the accuracy of the
cutting.
6237
Thickness problem
frame bottom
Invalid thickness of P2 and P3. Thickness of these points varies too much from
each other AND varies also from P1 & P4! This will influence the accuracy of the
cutting.