User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
96 AP-75280 – Rev. 1.2
Error
Message
Description
Solution
Category
6201
EPOS alignment aborted General message
- Error
6202
EPOS alignment aborted Lever was pulled up
6203
EPOS alignment aborted Alignment procedure has been aborted by the user
6206
Movement failed Movement failed during EPOS routine (moveabsc)
Error
6207
Movement failed Movement failed during EPOS routine (drawcontrol)
6208
Movement failed Movement failed during EPOS routine (scanroutine)
6211
Barcode problem occurred Barcode too long
Rescan the job and if the error still
occurs, try to:
 Replot the job
 Reprint the job
► Contourcutting ► Square details
Error
6212
Barcode problem occurred Barcode width problem
6213
Barcode problem occurred Barcode height problem
6214
Barcode problem occurred Barcode scan problem 1 (lower line of barcode)
6215
Barcode problem occurred Barcode scan problem 2 (upper line of barcode)
6216
Barcode problem occurred Checksum not OK
6218
Media size problem
Check if the margins left, right, top and bottom are within the
specifications
It might be possible that the file you have sent is not correct
► Did you sent the correct file?
► Contourcutting ► Square details
Error
6221
Page problem occurred PG after job failed
Check the media size Error
6222
Page problem occurred PG between 2 segments failed
6223
No EPOS reference found During search with EPOS laser, no edge was found (colour ↔ white) ► Test ► EPOS readout Error
6225
Possible data clip detected
One or more frame points lie outside hardclip region. Plot data will be
clipped.
Outer pressure rollers are inside
frame
► Basics ► Loading media
Warning
6226
Print distortion – bad
rectangle
Original print distortion. No perfect rectangle, no parallel sides
(difference > 3mm)
Bad print quality or outside specs
► Contourcutting ► Square details
Warning