User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
95 AP-75280 – Rev. 1.2
8.2.2 Contourcutting errors and warnings
When a specific contour cutting warning or error occurs, an error number will be displayed and a cross will be cut in the lower right corner. All codes are unique and
the cross has a predefined angle and size to know of which nature the error is.
Pre-difened crosses Single frame calibration points Multi frame calibration points
Please find below an overview of the codes and category of problem
• A warning means that you will have the choice to continue cutting the current segment, all segments or to cancel the job.
• An error means that you will have to retry the scanning routine. The reading of the frame has been cancelled
1. Print distortion - Bad rectangle
2. Media shift detected
3. Print distortion - Stretch
4. Possible data clipped
5. Thickness problem
1
3
5
4
2
P1
P2P3
P4
P5
P8
P6P7
P1
P2P3
P4
P5P8
P6P7
P11P12
P9P10
P11P12
P9P10
1st segment
middle segment
last segment