User`s guide

User’s Guide SC-PRO Cutting Plotter

CHAPTER 8: TROUBLESHOOTING

AP-75280 – Rev. 1.2

8.1.2 For network connections

Step 1 : Boot-up your computer.

Step 2 : Switch on the cutter.

Step 3 : After the initialization routine is finished, install a knife or pen in the head, select the proper tool

and load a sheet of media, which is at least 12 x 12 centimetres.

Step 4 : Open a text editor and type the following:

Step 5 : Save the file to your hard disk with the name and extension: “TEST.plt”.

Step 6 : Open “HyperTerminal”

(Accessories > Communications)

Step 7 : Type a name for the new connection, for example: SC-Pro and press [OK].

Step 8 : Switch the “Connect using:“ choice to TCP/IP (Winsock).

Step 9 : Type the IP-address of the cutter in the “Host address” field and 10001 as “Port number”.

Step 10 : Send the plot file via: Transfer > Send text file.

Step 11 : The file you have created will now be sent to the cutter, causing it to cut/draw a square of 10 by

10 cm and a circle with a radius of 5 cm.