User`s guide

User’s Guide SC-PRO Cutting Plotter

CHAPTER 7 : MAINTENANCE

AP-75280 – Rev. 1.2

7.1.2 Cleaning the cutter blade

Use following procedure to remove small vinyl particles in the base part of the cutting blade holder.

Step 1 : Hold the body (2) into one hand and

unscrew the base part (1).

STANDARD KNIFE HOLDER

Step 2 : Remove the spring (3) and the cutting

blade (4).

Step 3 : Blow away vinyl particles accumulated

in the top of the base part.

Step 4 :

Remove the spring from the cutting

blade and remove any residual material

from the blade tip

Step 5 : Place the spring back over the cutting

blade and tightly screw the base part on

the holder.

Step 1 : Take the body into one hand and remove

the base part.

KNIFE HOLDER WITH NONIUS

Step 2 :

Blow away the vinyl particles

accumulated in the top of the base part

Step 3 : Remove any residual material from the

blade tip

Step 4 : Place the base part on top of the holder

assembly and twist it tightly.

7.1.3 Cleaning the cutting plotter

Use a soft cloth to clean paper dust and particles off the platen, the grid cover the cutting mat and the

carriage cover.

Use a cotton swab to clean the media sensors and EPOS laser.