User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 6 : CONTOURCUTTING
85 AP-75280 – Rev. 1.2
6.4 CUT AREA MEASUREMENT
As explained above, different alignment methods can be chosen. Each method has a different measurement
method.
Step 1 : Press the [CONTOUR CUTTING] key.
Step 2 : Select the alignment method with the - keys.
Contourcutting
Manual
Barcode Single
Barcode Multi
Start: Next:
Step 3 : Press the [CONTOUR CUTTING]-key to make a selection and continue to the next setting.
Step 4 : The next screen depends on the previous selection.
d. When you have selected “Barcode Single or Multi”, the following can be set.
Contourcutting
X Length (mm)
Y Width (mm)
Roll direction
Start: Next:
► Press the [CONTOUR CUTTING]-key to set the X-length. Use the keys to change
the value. Press the [ ]-key to go to the previous screen.
Adjust the Y-width and roll direction in the same way.
Contourcutting
X Length (mm)
500
Start: Exit:
Contourcutting
Y Width (mm)
300
Start: Exit:
Contourcutting
Roll direction
(Non)Reverse
Start: Exit: