User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 6 : CONTOURCUTTING
79 AP-75280 – Rev. 1.2
6 CONTOUR CUTTING
CONTOUR CUTTING is a very popular feature of the SC PRO cutter.
This feature is made to cut pre-printed signs on vinyl for sticker
production as shown on this picture ► ► ► ► ► ►
Please read this chapter carefully. Because of the importance of this
feature, almost a complete manual is written about it. So please refer to
the Application Guide for all necessary information.
The information below is some basic information about the different
alignment methods …
6.1 DIFFERENT ALIGNMENT METHODS
There are some different approaches to cut your signs which also implicate a different alignment method.
1. Manual
Manual alignment method.
o Manually set the size of the paper and 4 corners of the box.
2. Auto No BC
Automatic alignment method without barcode
(only selectable via
o Automatic measurement of the reference box (job data).
the cut software)
o Only 1 box
3. Barcode Single
Automatic alignment with barcode and single frame
o Automatic measurement of the reference box and barcode (job data).
o Only 1 reference box
4. Barcode Multi
Automatic alignment with barcode and multi-segment frame.
o Automatic measurement of the reference box and barcode (job data).
o Multiple segments in 1 reference box (for long files to guarantee precision).
Manual
Auto No BC
BCode Single
BCode Multi
P4 P2
P3 P1
0000000000000
0000000000000