User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 5 : FINETUNING YOUR CUTTER
78 AP-75280 – Rev. 1.2
5.6 XY-DISTANCE ACCURACY
The XY - Distance Accuracy tests are developed to check the actual X-Y cutting distance with the sent
vector data.
Please follow the procedure below to make the test:
Step 1 : Open Mutoh’s CutServer
Step 2 : Select which test to perform.
Step 3 : Select the appropriate COM-port and double-click.
Step 4 : Load a roll or sheet with at least the measurements indicated in the dropdown menu.
Step 5 : Load a knife.
Step 6 : A box will be cut.
Step 7 : Peel out the box.
Step 8 : Measure the X length and Y width and enter them. Be sure to enter the values in mm!
Step 9 : If the correct values have been entered, the following message will appear and the test will be
done.