User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 5 : FINETUNING YOUR CUTTER
76 AP-75280 – Rev. 1.2
5.5 CUT THROUGH TEST
This test has been developed to test the set values for cutting through applications.
Proceed as follows to make the test
Step 1 : Install and set a knife.
Step 2 : Install a vinyl.
Step 3 : Press the [TEST]-key.
Step 4 : Select “Cut Through” with the - keys and press the [ ]-key to open the menu.
Test
Cut Through
10 cm/s 250 g
To start:
Step 5 : Select the Setup menu with the - keys and open it with the [ ]-key
Cut Through
Setup
Test
Start: Exit:
Step 6 : Press the [ ]-key to set the force, speed, tool down cutting length and tool up feeding length.
Browse (and accept) the settings with the [ ]-key.
Cut through
Force (g)
250
Next: Exit:
Cut through
Speed (cm/s)
10
Next: Exit:
Cut through
Tool down (mm)
10.0
Next: Exit:
Cut through
Tool up (mm)
0.1
Done: Exit:
Step 7 : Select “Test” and press the [ ]-key.
Cut Through
Setup
Test
Start: Exit: