User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 5 : FINETUNING YOUR CUTTER
72 AP-75280 – Rev. 1.2
5.4.2 EPOS readout
This function is made to test if the EPOS sensor still recognizes the difference between coloured and white
media.
Test
EPOS readout
60 cm/s 100 g
To start:
Step 1 : Press the [ ] key to start the test.
Step 2 : The EPOS laser will light up and the following message will be displayed:
EPOS readout
COLOUR
Verify media
Step 3 : Hold a white paper under the EPOS laser and check if the display message changes to WHITE.
If not, the sensor is broken or badly positioned. Contact an Authorized Mutoh Technician to
replace or calibrate the EPOS sensor.
Step 4 : Press the [ ] key to end the test and to go back to the main screen.