User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 5 : FINETUNING YOUR CUTTER
71 AP-75280 – Rev. 1.2
Step 9 : Launch the job in one of the two possible ways:
a. Directly from the SC-Pro keyboard
1. Press the contour button key and select BarCode Single – Single Scan.
Contourcutting
Barcode Single
Barcode Multi
Start
Next:
Contourcutting
Single scan
Multi scan
Start: Exit:
2. Press the [ ]-key to start the test.
b. Using the Mutoh CutServer
1. Make following settings: Single Scan – Single Frame Mode and Save Settings.
2. Press the [GO] button to start the test.
Step 10 : The reference box will be automatically measured and the barcode verification will be executed.
When the plot file is not listed in the Mutoh CutServer, the internal embedded Epos Final Check
plot file will be used.
Step 11 : The pre-printed contour data will be replot.
Step 12 : Verify the positioning of you contour plot data.
5.4.1.3 Adjustments if necessary
It might be possible that the contour positioning is not correctly.
Please perform the following extra tests to optimize it:
1. Recalibrate your laser beam by means of the Epos Calibration test as described in the next chapter.
2. Verify your X-Y lengths via the Mutoh CutServer (SC-Pro Tests menu)