User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
62 AP-75280 – Rev. 1.2
4.3.4 Updating the keyboard
After installation of a new cutter firmware, it is highly recommended to update the keyboard firmware as
described below:
Step 1 : Power ON the cutter.
Step 2 : Install the new firmware.
Step 3 : Press the special key combination to start the installation.
+ + +
Step 4 : Confirm that you want to update the keyboard firmware.
Update
Keyboard?
Yes :
or
No :
or
Step 5 : The following message will be displayed:
Keyboard update!
Please wait...
DO NOT SHUTDOWN!
The installation will take approximately 1 minute.
Step 6 : After installation, a beep will sound and the main screen will be displayed again.
4.3.5 Reset the keyboard
It might be possible that the keyboard does not correspond anymore. To avoid to reboot the cutter; a special
key combination is made available to reset the keyboard.
Step 1 : Press the special key combination to start the installation.
+ + +
Step 2 : The keyboard will reset and the main screen will be displayed again.
Step 3 : If the keyboard does not respond still, you have to reboot the cutter.