User`s guide

User’s Guide SC-PRO Cutting Plotter

CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL

AP-75280 – Rev. 1.2

4.3.2 EPOS laser OFF

Deactivate the EPOS laser as follows

Step 1 : Power ON the cutter.

Step 2 : Press the following keys simultaneously:

Step 3 : The EPOS laser will go out.

4.3.3 Bar code verification

This function makes it possible to check if the scanned barcode corresponds with the real barcode number.

How to verify a barcode:

Step 1 : Load a vinyl with a barcode on.

Step 2 : Activate the EPOS laser as described above.

Step 3 : Position the EPOS laser in front (left side) of the barcode using the arrow keys.

52000310804

Step 4 : Press the special key combination to start the barcode verification scan.

Step 5 : The cutter will scan the barcode. Following messages can appear:

BARCODE OK

- > NON- MIRRORED

- > CODE:

52000310804

BARCODE

RECOGNITION

ERROR

RETRY

Step 6 : If the barcode number displayed (52000310804) corresponds with the number under the

barcode, everything is all right. If not, a print mismatch could be the problem.