User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
58 AP-75280 – Rev. 1.2
4.2.23 Serial communication
In order for your plotter to be able to communicate well with your host computer, the communication settings
on both machines have to match exactly. Please refer to the manual of your software to determine which
communication setting will be used by your software. Your cutter can be set up to use any settings
necessary.
To change the communication selection, please follow the instructions mentioned below:
Step 1 : Select with the - keys the setting you want to change.
Baudrate
DataBits
Parity
StopBits
FlowControl
RS232/USB/ETH
Step 2 : Press the [ ] – key to confirm your selection.
Step 3 : Change the value with the - keys and confirm once again with the [ ] – key.
Step 4 : Return to the main menu of the serial communication settings and change all the other settings if
necessary.
The following settings can be made.
• Baudrate 1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600 or 115200
• DataBits 7 or 8
• Parity None, even or odd
• StopBits 0, 1 or 2
• FlowControl Software or hardware
• RS232/USB/ETH Auto, Serial, USB or Ethernet connection