User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
48 AP-75280 – Rev. 1.2
4.2.1 Sheet off mode
The auto-sheet-off mechanism of your cutter can be very easily used to cut the front edge of a new roll of
vinyl straight as well as to cut off a sheet of vinyl from a roll, to be used as a separate sheet.
With the sheet-off mode, you can select “AUTOMATIC”, “MANUAL” or “DISABLE”.
Sheetoff Mode
AUTOMATIC
Save: Exit:
Sheetoff Mode AUTOMATIC
A sheet-off will be done automatically when pressing the
sheet-off key.
MANUAL
A sheet-off can be done with a snap-off blade knife; the media will
feed towards the cut groove after a job is done.
DISABLE No sheet-off possible.
4.2.2 Sheet off margin
It is sometimes useful that the media is fed an amount of millimetres after a job, before sheeting off.
Sheetoff Margin
5
[mm]
Save: Exit:
Sheetoff Margin 1 – 5 – 250 [mm]
The media will be fed 5 mm extra before sheeting off.
4.2.3 Auto Shuffle
Set if it is necessary to perform an automatic media shuffle after a sheet-off procedure.
Sheetoff Mode
AUTOMATIC
Save: Exit:
Auto Shuffle ENABLED
An automatic shuffle will be executed after a sheet-off
Disabled No automatic shuffle will be executed after a sheet-off