User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
43 AP-75280 – Rev. 1.2
4.1.7 OFFSET key
Please follow the instructions below to change / control the offset.
Step 1 : Press the [OFFSET] key.
Step 2 : The current offset (in mm) will be displayed. Change the value with the - keys.
Offset
0.50
[mm]
Start: Exit:
Step 3 : Press the [ ] key to change/test the current value or the [ ] key to abort.
Step 4 : The following message will be displayed when you have changed the value:
Test offset
Test : or
No test : or
Step 5 : The following pattern will be cut:
Each square will be cut with a different offset.
Step 6 : Use the keys to forward the media.
Step 7 : Weed out the boxes as and check the patterns and determine which of them gives best quality.
Especially look for good quality of the corners and easy weeding.
Step 8 : Select one of the offsets with the left-right arrow keys. The EPOS laser will point to the selected
offset / test pattern.
Step 9 : Press the [ ] key to accept the new offset.
0,45 0,46 0,47 0,48 0,49 0,50 0,51 0,52 0,53 0,54