User`s guide

User’s Guide SC-PRO Cutting Plotter

CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL

AP-75280 – Rev. 1.2

b. When you have selected “Barcode Single” or “Barcode Multi”, you have to decide if the job

has to be performed only once (“Single Scan”) or multiple times (“Repeat Mode”).

Contourcutting

Single scan

Repeat Mode

Start: Exit:

► Press the - key to start the scanning of the reference box.

c. When you have selected “Trim Poster”, you have to fill in the X and Y length of the poster

you want to trim.

Trim poster

X Length( mm)

200

Next: Exit:

Trim poster

Y Width( mm)

200

Start: Exit:

► Press the -key to activate the EPOS LED.

► Select the first corner of the bounding box which you want to trim with the keys

Trim poster

Please select

the corner

Next: Exit:

► Press the -key to proceed to the second corner. The media will be fed the previously

set length and width.

► Do this until you have selected all 4 corners in correct order (P1 – P2 – P3 – P4)

► The cutter will PAUSE until you have inserted the “through cut tool”.

X Length

Y Width