User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL
38 AP-75280 – Rev. 1.2
4.1.4 CONTOUR CUTTING key
Please follow the instructions below to select an alignment method, to set parameters and to start contour
cutting.
F
OR MORE INFORMATION ON HOW TO CONTOUR CUT, PLEASE REFER TO:
► THE APPLICATION GUIDE DESCRIBING ALL DETAILS ABOUT CONTOUR CUTTING.
► CHAPTER 6 OF THIS MANUAL
Step 1 : Press the [CONTOUR CUTTING] key.
Step 2 : Select the alignment method with the - keys and confirm with the - key.
Contourcutting
Manual
Barcode Single
Barcode Multi
Trim Poster
Next: Exit:
Step 3 : The next screen depends on the previous selection.
a. When you have selected “Manual”, the following can be set.
► Set the X-length. Use the keys to change the value. Press the [ ]-key to go to the
previous screen. Press the key to proceed to the Y width
Contourcutting
X Length (mm)
500
Start: Exit:
► Adjust the Y-width and roll direction in the same
way.
Contourcutting
Y Width (mm)
500
Start: Exit:
Contourcutting
Roll direction
(Non)Reverse
Start: Exit:
► Press the - key to start the scanning of the reference box.