User`s guide

User’s Guide SC-PRO Cutting Plotter

CHAPTER 4 : WALKTHROUGH THE OPERATION PANEL

AP-75280 – Rev. 1.2

4.1.2 ORIGIN key

Please follow the instructions below to change / control the origin.

Notes

Please make sure media is loaded. If not, the SC-Pro positioning calculation is based on previously

installed media.

Step 1 : Press the [ORIGIN] key.

Step 2 : The EPOS laser will be activated automatically. The display will show following message:

Origin

Set new:

Move to:

Move with

◄►▲▼

Step 3 : Press the [ ] key to move to the actual origin and/or use the keys to move the laser to the

desired origin position and press the [ ] key to set the new origin.

Step 4 : The main screen will automatically be displayed again.

4.1.3 TEST key

To be able to contour cut, an Epos® feature has been incorporated. This feature will search for the black

reference box and measure the position of the design(s). When you see some deviation during contour

cutting, it is recommended to perform the test cuts described below.

For some applications it is necessary to be able to cut through the media. Various settings such as speed,

force, tool up and tool down length can be set ant tested here.

Step 1 : Press the [TEST] key.

Step 2 : Select one of the tests with the - keys.

Test Test

EPOS readout

EPOS calibrate

60 cm/s 100 g METHOD: <TEST>

To start: To start:

Test

Cut Through

10 cm/s 250 g

To start:

Notes

Please refer to chapter 5 for all details about these tests.