User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 3 : BASICS
32 AP-75280 – Rev. 1.2
Step 8 : Be sure that the media is cut off straight at the front to avoid media initialization mismatches.
Notes
Before lowering the pressure rollers, be sure that there is a knife or pen installed in the head. This because
during the media initialization, the penhead will also be initialized. If you insert a pen/knife afterwards, the
machine will not know how to wind the coil of the penhead. This could result in cutting lines across the
complete print.
Step 9 : Pull the lever down. This action will initialize the media loading sequence, during which the cutter
will shuffle a pre-set distance of vinyl (Pre-Feed Length). The following messages can be
displayed:
Roll front Roll
Please wait Please wait
Notes
• The head will move fast over the media. Be careful not to pinch your fingers during this action.
•
Please refer to “chapter 4 - Pre-feed Length” to understand the important function of this feature.
Step 10 : After a successful measurement, the main screen will appear. The width of the media will be
displayed:
*READY*
X Roll
Y 500
Drag Knife Tool
60 cm/s 100 g
Step 11 : The SC-Pro is ready to receive data from the host computer or Mutoh CutServer.