User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 3 : BASICS
25 AP-75280 – Rev. 1.2
Step 6 : Remove the backing of the new cutting mat and install it in the cutting groove.
a. Depending on the type of grid roll cover, the cutting mat should be installed differently. You
can recognize the type of cover by the amount of holes at the left side (refer to picture
below).
i. For TYPE 1
Stick the cutting mat as close as possible to the rear of the machine.
ii. For TYPE 2
Stick the vinyl as close as possible to the front of the machine.
Step 7 : Reinstall the Y-rail cover
Step 8 : If you notice some cutting errors after replacing the cutting mat, it might be necessary to contact
an Authorized Mutoh technician to perform a Y-Z profile measurement and sheeting-off knife
adjustment.
TYPE 1 TYPE 2
REAR FRONT
REAR FRONT