User`s guide

User’s Guide SC-PRO Cutting Plotter

CHAPTER 3 : BASICS

AP-75280 – Rev. 1.2

3.1.4 Replacing the cutting mat

To replace the cutting mat, proceed as follows:

Step 1 : To easy the replacement procedure, it is recommended to remove the Y-rail cover (1) by

loosening the 4 screws. Experienced users might do this without removing the cover.

Step 2 : Remove the worn cutting mat (1) by pulling it out (or use a flat screwdriver)

Step 3 : Gently scrape out the remaining glue with a flat screwdriver. Do NOT damage the cutting groove

by pulling scratches in it.

Step 4 : Clean the cutting groove with isopropanol.

Step 5 : Apply Loctite 406 in the middle and sides of the cutting groove.