User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 1 : SAFETY INSTRUCTIONS
12 AP-75280 – Rev. 1.2
1.2 IMPORTANT NOTES
Technical problems and maintenance, which require the cutter to be opened, can only be done by
qualified personnel who were trained to repair this type of machine.
Unauthorized removing of covers and/or overruling safety locks can be dangerous and will result in
your guarantee becoming void.
After powering OFF the machine, wait at least 10 seconds before powering ON again. Not respecting
this time interval could damage the machine.
1.3 SAFETY LABELS
Be careful when servicing this machine. The cutter has two fuses.
One neutral and one in phase.
After operation of the fuse, parts of the equipment that remain
energized might represent a hazard during servicing.
Maximum CW Laser Power 5mW
Wavelength 650nm
IEC 60825-1:2007 2nd Ed.
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
CAUTION – CLASS 2
LASER RADIATION WHEN OPEN.
DO NOT STARE INTO THE BEAM
Be sure not to stare in the laser mounted on the cutting head.
Be careful not to pinch your fingers between the
pressure rollers and grid rollers when loading
media for example.