User`s guide

User’s Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
103 AP-75280 – Rev. 1.2
5061 LASER caused an error
5066 KNIFE caused an error
5067 EPOSSEDGE caused an error
5068 EPOSPARS caused an error
5069 EPOSCALIB caused an error
5070 EPOSDIST caused an error
5071 EPOSALIGN caused an error
5072 EPOSSCAN caused an error
5073 ESOSSPEED caused an error
5076 PIOS caused an error
5077 DPSERV caused an error
5078 DPVECT caused an error
5079 CLSERV caused an error
5080 CLVECT caused an error
5088 PENUPSPEED caused an error
5089 ENDPLOT caused an error
5090 HPGLM caused an error
--------------------------------------------------------------------------
6000 I2C SW BUSY timeout
6001 I2C SW RECEIVE timeout
6002 I2C HW MBB timeout
6003 I2C HW MIF timeout
6004 I2C Stop command failed
6006 I2C HW RXAK no ack from slave in adr cycle
6015 I2C SetData command failed
6016 I2C GetData command failed
6017 I2C PIOSet command failed
6018 I2C Read command failed
6019 I2C GETDATA IN SEARCHSENSOR
6021 I2CSTOP IN SEARCHSENSOR
6023 PROBLEM IN SETKNIFE
6024 PROBLEM IN SETLASER
--------------------------------------------------------------------------
6050 KEYB communic. checksum problem
6060 KEYB COMM error
6061 KEYB sendtokeybproblem
--------------------------------------------------------------------------
6070 SFWT delay_ctf problem
6071 SFWT match_intu problem
6072 SFWT delay problem
6073 SFWT release error
--------------------------------------------------------------------------
6080 Moveabsmc problem
6090 EPOS Mbus read blocks
6091 EPOS Mbus stop blocks
6092 EPOS calc pen to led search edge blocks
6093 EPOS auto calibrate search edge blocks
6094 CALIBRATE PROBLEM IN AUTOCALIBRATE 1
6095 CALIBRATE PROBLEM IN AUTOCALIBRATE 2
6096 EPOS calibrate get data blocks
6097 EPOS calibrate pen to led blocks
--------------------------------------------------------------------------
6100 BUMP PROBLEM MACHINE WIDTH
6105 X MEASUREMENT PROBLEM RELOAD MEDIA
6106 SHUFFLE PROBLEM2
6107 SHUFFLE PROBLEM3
6108 SHUFFLE PROBLEM4
6109 SHUFFLE PROBLEM5
6110 SHUFFLE PROBLEM TEST
--------------------------------------------------------------------------
6111 DRAM overrun error
6112 SRAM overrun error
6114 Wrong firmware on this mainboard