User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev. 2.0, 26/11/04

Step 10 : On front of the printer, take the media and pull straight (until you become an equal tension on the

left and right of the media). Do not pull in the middle of the media.

Step 11 : Lower the pressure rollers of the printer.

Step 12 : Set the unwinder (REAR) unit to AUTOMATIC

The rear tensioning system will go to it’s initial position.

Step 13 : Close the front cover

Step 14 : Either start printing, or use the printer media feed to create a free media end on front of the

printer.

Step 15 : Use some tape to fix the media end to the front empty core installed on the winder unit. Start

taping the middle of the media, then the both ends, applying equal tension on both ends.

Notes :

With a small intervention it is possible to reverse your winding direction.

Mount a cable between the control box and the front motorized unit cable.

Step 16 : Set the winder (FRONT) unit to ACTIVE. The front tensioning system will be activated.

Step 17 : Installation of the media is completed.