User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev. 2.0, 26/11/04

4.7.2.2. When unwinding the media with the printable side on the inside.

Step 1 : Make sure the printer and unwinder / winder 100 are ON.

Step 2 : Press the [F4] key to raise the pressure roller.

Step 3 : Open the front cover.

Step 4 : Put the media roll between the motorized roll unit and roll unit of the unwinder unit.

a. Position in the middle of the printer (use hole pattern in the steel bar).

b. Make sure no slip occurs.

1 : Holes in the steel bar

Step 5 : Install an empty core between the motorized roll unit and roll unit of the winder unit on front of the

printer. → Make sure the core is longer then the media width.

Step 6 : Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.

Step 7 : Use the foot-switch to release some media on the rear.

Step 8 : Load media through the rear tensioning system as described below.

1 = Unwinder System 2 = Rear Tension System

3 = Insertion slot

Step 9 : Load the media through the printer’s pressure rollers.