User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev. 2.0, 26/11/04

Step 11 : Lower the pressure rollers of the printer.

Step 12 : Set the unwinder (REAR) unit to AUTOMATIC

The rear tensioning system will go to it’s initial position.

Step 13 : Close the front cover

Step 14 : Either start printing, or use the printer media feed to create a free media end on front of the

printer.

Step 15 : Use some tape to fix the media end to the empty core installed a the winder unit. Start taping the

middle of the media, then the both ends, applying equal tension on both ends.

Notes :

With a small intervention it is possible to reverse your winding direction.

Mount a cable between the control box and the front motorized unit cable.

Step 16 : Set the winder (FRONT) unit to ACTIVE. The front tensioning system will be activated.

Step 17 : Installation of the media is completed.